EV CHARGER USER GUIDE & TROUBLESHOOTING

IMPORTANT:

DO NOT PRESS EMERGENCY STOP BUTTON TO END CHARGING SESSION

THIS BUTTON IS ONLY TO BE USED IN CASE OF EMERGENCY

FOR EV CHARGING POINT USERS

UNABLE TO REMOVE CABLE FROM EV CHARGER

IF YOU ARE UNABLE TO REMOVE YOUR CABLE FROM THE EV CHARGER - DO NOT PRESS THE EMERGENCY STOP BUTTON. THIS WILL LOCK THE CABLE INTO THE CHARGER AND REQUIRE THE CHARGING UNIT TO BE RESET.

IN THE EVENT OF A STUCK CABLE, PLEASE ENSURE THE CABLE IS FULLY PUSHED INTO THE EV CHARGING UNIT, AND IS CONNECTED TO YOUR VEHICLE. START A NEW CHARGING SESSION FOLLOWING THE OPERATING INSTRUCTIONS BELOW. FOLLOW THE INSTRUCTIONS TO END THE SESSION, ENSURING YOU DISCONNECT THE CABLE FROM THE EV CHARGER FIRST, AND THEN DISCONNECT FROM THE VEHICLE.

FOR EV CHARGING POINT OWNERS

IF AFTER FOLLOWING THE PREVIOUSLY MENTIONED STEPS A CABLE IS STILL STUCK IN A CHARGER, PLEASE COMPLETE THE FOLLOWING:-

PLEASE CHECK IF THE EMERGENCY STOP BUTTON HAS BEEN PRESSED. IF SO, PLEASE RESET THE BUTTON BY TURNING IT CLOCKWISE UNTIL THE BUTTON POPS OUT.

ENSURE THE CABLE IS FULLY PUSHED INTO THE CHARGING UNIT.

SWITCH OFF THE MAIN REMOTE ISOLATION SWITCH AND LEAVE THE UNIT OFF FOR 3 MINUTES.

SWITCH THE UNIT BACK ON.

PLEASE NOW REMOVE THE CABLE FROM THE EV CHARGER.

OPERATING INSTRUCTIONS

TO START CHARGING SESSION

1. CONNECT CABLE TO EV CHARGER AND THEN TO CAR

2. TAP RFID CARD/FOB TO START CHARGE

TO END CHARGING SESSION

PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY

1. TAP RFID CARD/FOB TO END CHARGING SESSION

2. REMOVE CABLE FROM EV CHARGER FIRST

3. REMOVE CABLE FROM CAR

IMPORTANT:

DO NOT PRESS EMERGENCY STOP BUTTON TO END CHARGING SESSION

THIS BUTTON IS ONLY TO BE USED IN CASE OF EMERGENCY